|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Hello from Germany - thank you very much for the manual for my Sharp "Searcher" - the handling of your internet area is outstanding..Mike
;
I am very happy with the owner's manual. I bought a used Casio and was so relieved that I was able to get a hold of a owner's manual. It was very easy to download the manual and I had no problems with printing it. Thank you! Nancy Whalen
;
The purchased manual is an high-quality scan of the original JVC paper-based Owner´s Manual. I am very satisfied!
;
Very satisfied with received document, all is right, Thank You very much, it was a Pleasure to work with You.
 ;
great site, the most easy and fastest way to find the manual you need, no 5 star because the manual was only available in german, but I speak german as well so no problem for me.
68
EN
TROUBLESHOOTING (cont.)
POSSIBLE CAUSES
39. � The speaker volume is too great. 40.
����
SYMPTOM
39. Images on the LCD monitor are jittery. 40. The LCD monitor, the viewfinder and the lens have become dirty (ex. fingerprints). 41. An unusual mark appears.
CORRECTIVE ACTION
39. � Turn the speaker volume down ( pg. 42). 40. � Wipe them gently with soft cloth. Wiping strongly can cause damage. 41. � Check the section of the manual that explains LCD monitor/viewfinder indications ( pg. 72, 73). 42. � Remove the power supply (battery pack, etc.) and wait a few minutes for the indication to clear. When it does, you can resume using the camcorder. If the indication remains even though you repeat the above two or three times, please consult your nearest JVC dealer. 43 � To protect the battery, it is recommended to charge it in places with a temperature of 10°C to 35°C ( pg. 76). 44.
����
41.
����
42. An error indication (E01 � E06) appears.
42. � A malfunction of some kind has occurred. In this case the camcorder�s functions become unusable.
43. The charger indicator on the AC Power Adapter/Charger does not light.
43. � The temperature of the battery is extremely high/low. � Charging is difficult in places subject to extremely high/low temperatures. 44. � This occurs when recording in the LP mode is not available. After the indicator blinks, the recording mode switches to �SP� and recording goes on. 45. � The viewfinder is pulled out. � The LCD monitor's brightness setting is too dark.
44. The recording mode indicator �LP� blinks.
45. Picture does not appear on the LCD monitor.
45. � Push the viewfinder back in. � Adjust the brightness of the LCD monitor ( pg. 17). � If the monitor is tilted upward 180 degrees, open the monitor fully ( pg. 16). 46. � By recording with �DIS� activated ( pg. 29) this can be avoided. 47. � Turn the camcorder�s power off and on again, then operate it.
46. When the image is printed from the printer, a black bar appears at the bottom of the screen. 47. When the camcorder is connected via the DV connector, the camcorder does not operate.
46. � This is not a malfunction.
47. � The DV cable was plugged/ unplugged with power turned on.
|
|
|
> |
|
