|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
;
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
;
The owners manual is very good. all my how to questions were answered in detail.
68
EN
TROUBLESHOOTING (cont.)
POSSIBLE CAUSES
39. � The speaker volume is too great. 40.
����
SYMPTOM
39. Images on the LCD monitor are jittery. 40. The LCD monitor, the viewfinder and the lens have become dirty (ex. fingerprints). 41. An unusual mark appears.
CORRECTIVE ACTION
39. � Turn the speaker volume down ( pg. 42). 40. � Wipe them gently with soft cloth. Wiping strongly can cause damage. 41. � Check the section of the manual that explains LCD monitor/viewfinder indications ( pg. 72, 73). 42. � Remove the power supply (battery pack, etc.) and wait a few minutes for the indication to clear. When it does, you can resume using the camcorder. If the indication remains even though you repeat the above two or three times, please consult your nearest JVC dealer. 43 � To protect the battery, it is recommended to charge it in places with a temperature of 10°C to 35°C ( pg. 76). 44.
����
41.
����
42. An error indication (E01 � E06) appears.
42. � A malfunction of some kind has occurred. In this case the camcorder�s functions become unusable.
43. The charger indicator on the AC Power Adapter/Charger does not light.
43. � The temperature of the battery is extremely high/low. � Charging is difficult in places subject to extremely high/low temperatures. 44. � This occurs when recording in the LP mode is not available. After the indicator blinks, the recording mode switches to �SP� and recording goes on. 45. � The viewfinder is pulled out. � The LCD monitor's brightness setting is too dark.
44. The recording mode indicator �LP� blinks.
45. Picture does not appear on the LCD monitor.
45. � Push the viewfinder back in. � Adjust the brightness of the LCD monitor ( pg. 17). � If the monitor is tilted upward 180 degrees, open the monitor fully ( pg. 16). 46. � By recording with �DIS� activated ( pg. 29) this can be avoided. 47. � Turn the camcorder�s power off and on again, then operate it.
46. When the image is printed from the printer, a black bar appears at the bottom of the screen. 47. When the camcorder is connected via the DV connector, the camcorder does not operate.
46. � This is not a malfunction.
47. � The DV cable was plugged/ unplugged with power turned on.
|
|
|
> |
|
