|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
GETTING STARTED
Hook on.
USING THE BATTERY PACK
Perform step 1) of �CHARGING THE BATTERY PACK�.
Approximate recording time (unit: min.) Battery pack Push in. BN-V11U BN-V12U (optional) BN-V20U (optional) BN-V400U (optional) Viewfinder on LCD monitor on
1
95 (50) 95 (50) 150 (85) 360 (205)
2
100 (50) 100 (50) 165 (90) 385 (210)
1
80 (45) 80 (45) 135 (75) 315 (190)
BATTERY RELEASE Switch
Battery pack
1 When using models equipped with LCD monitor 2 When using GR-SX970
( ): when the video light is on Power Switch To DC IN connector AC Adapter To AC outlet
USING AC POWER
Connect the AC Adapter to the camcorder ( step 2) and 3) of �CHARGING THE BATTERY PACK�). � The provided AC Adapter features automatic voltage selection in the AC range from 110 V to 240 V. ATTENTION Before detaching the power source, make sure that the camcorder�s power is turned off. Failure to do so can result in a camcorder malfunction.
CHARGING THE BATTERY PACK
1) Hook the end of the battery pack to the camcorder and push the battery in until it locks in place. � If the battery pack is attached in the wrong position, a malfunction may occur. 2) Set the Power Switch to �OFF�. Connect the AC Adapter to the DC IN connector 3) Plug the AC Adapter into an AC outlet. The CHARGE lamp blinks to indicate charging has started. 4) When the CHARGE lamp stops blinking but stays lit, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.
@ 9. * *
REFRESH:
Be sure to fully discharge a battery pack before recharging or storing it for a long period of time, otherwise the battery performance will be reduced. 1) Perform steps 1) through 3) of �CHARGING THE BATTERY PACK�. 2) Press REFRESH for over 2 seconds. The REFRESH lamp blinks to indicate discharging has started. 3) When discharging is finished, charging
r (
To Detach The Battery Pack . . . ... slide BATTERY RELEASE and pull out the battery pack.
8
automatically starts and the CHARGE lamp blinks.
*
Battery pack BN-V11U BN-V12U (optional) BN-V20U (optional) BN-V400U (optional)
Charging time approx. 1 hr. 30 min. approx. 1 hr. 30 min. approx. 2 hrs. 20 min. approx. 4 hrs. 30 min.
Charge marker helps you remember whether the battery pack has been charged or not. Two colors are provided (red and black)�you choose which one means charged and which means discharged.
Charging times are for a fully discharged battery pack.
6
|
|
|
> |
|
