|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
50
EN
USER MAINTENANCE
After Use
LENS COVER Open/Close Ring
1 2 3 4 5 6 1
Remove. PUSH Button EJECT Switch
Turn off the camcorder. Open the LCD monitor* fully. Slide EJECT to open the cassette holder, then remove the cassette. Press PUSH to close and lock the cassette holder. Close and lock the LCD monitor*. Slide BATTERY RELEASE to remove the battery pack. Turn the LENS COVER Open/Close Ring to close the lens cover.
BATTERY RELEASE Set to �OFF�.
Cleaning The Camcorder
To clean the exterior, wipe gently with a soft cloth. Put the cloth in diluted mild soap and wring it well to wipe off heavy dirt. Then wipe again with a dry cloth. Open the LCD monitor* and wipe gently with a soft cloth. Be careful not to damage the monitor*. Close the LCD monitor*. To clean the lens, blow it with a blower brush, then wipe gently with lens cleaning paper. To detach the eyepiece, turn it counterclockwise and pull it out. Remove dust from the viewfinder using a blower brush. Re-attach the eyepiece and turn it clockwise.
2 3 4 5 6
Remove. PUSH Button EJECT Switch
*GR-SXM320 only. NOTES: � Avoid using strong cleaning agents such as benzine or alcohol. � Cleaning should be done only after the battery pack has been removed or other power units have been disconnected. � Mold may form if the lens is left dirty. � When using a cleaner or chemically treated cloth refer to the cautions of each product. � When removing the eyepiece, be sure to hold the viewfinder securely.
|
|
|
> |
|
