|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
;
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
Connecting Your Subwoofer to Your Ampli�er JBL GT Series subwoofers are available in three different con�gurations: single 4-ohm voice coil, single 8-ohm voice coil and dual 4-ohm voice coils. Depending on the ampli�er you are using, you may use either single- or dual-voice-coil subwoofers in singles or multiples to maximize the power available from your ampli�er. To achieve the maximum ampli�er output possible, you should design a speaker system that provides the lowest impedance that your ampli�er is rated to drive safely. When designing a subwoofer system, abide by the following rules: 1. Don�t mix different subwoofer or enclosure types in the same system (use all single-coil 4-ohm woofers, all singlecoil 8-ohm woofers, or all dual-coil woofers).
2. You may connect the coils of a dualvoice-coil woofer in series, but NEVER connect separate woofers in series. Because the ampli�er-damping factor (the ampli�er�s ability to control the motion of the woofer) is expressed as a ratio of terminal impedance (the sum of speaker impedance, wire resistance and the D.C. resistance of any crossover coil connected to the woofer) to ampli�er-output impedance, connecting woofers in series reduces the damping factor of the ampli�er to a value less than 1. This will result in poor transient response. 3. You must use both coils of a dualvoice-coil woofer either in series or in parallel. 4. Most ampli�ers deliver exactly the same amount of power bridged into a 4-ohm load as they do running a 2-ohm stereo load.
To design a subwoofer system that maximizes available ampli�er power, keep the following rules in mind: 1. The total system impedance of woofers in parallel = 1/(1/w1 + 1/w2 + 1/w3...) where w is the nominal impedance of the woofer. 2. The total system impedance of voice coils (or woofers) in series = w1 + w2 + w3... The diagrams below and at right show parallel and series speaker connections. Figure 1. Parallel connection
Figure 2. Series connection
03
$4.99 GT1241 JBL Service Manual Complete service manual in digital format (PDF File). Service manuals usually contains circuit diagr…
|
|
|
> |
|