|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
;
excellent value & price! Includes everything you need to know about the NN-C777! I would buy this again.
SERVICE AND ADJUSTMENTS
FRONT WHEEL CAMBER
The front wheel camber is not adjustable on your tractor. If damage has occurred to affect the front wheel camber, contact your nearest authorized service center/department.
WASHERS RETAINING RING AXLE COVER
B
FRONT OF TRACTOR
FIG. 30
A
FIG. 28
ADJUSTMENT SLEEVES TIE ROD
TO START ENGINE WITH A WEAK BATTERY (See Fig. 31)
WARNING: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries. If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the Customer Responsibilities section of this manual). If �jumper cables� are used for emergency starting, follow this procedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.
JAM NUTS
FIG. 29
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL (See Fig. 30) � Block up axle securely. � Remove axle cover, retaining ring and washers to allow wheel removal. � Repair tire and reassemble. � Replace washers and snap retaining ring securely in axle groove. � Replace axle cover. REAR WHEEL � � � Block rear axle securely. Remove five (5) hub bolts to allow wheel removal. Repair tire and reassemble. Replace and tighten hub bolts securely. NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.
TO ATTACH JUMPER CABLES � Connect one end of the RED cable to the POSITIVE (+) terminal of each battery(A-B), taking care not to short against tractor chassis. � Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery. � Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery. TO REMOVE CABLES, REVERSE ORDER � BLACK cable first from chassis and then from the fully charged battery. � RED cable last from both batteries.
WEAK OR DEAD BATTERY
FULLY CHARGED BATTERY
FIG. 31
24
|
|
|
> |
|
