|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
;
The manual was properly scanned and perfectly readable. The only small problem is that I couldn't use my dear Ctrl + F to find a word I needed.
;
Nothing wrong with the manual or the delivery - came to me the same day I ordered it. But afterwards I realized that I ordered the wrong manual. Probably better with the Quick start - version. So maybe it would be better if we could see a list with inhold for each manual before ordering?
 ;
Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
;
Bought the used Philips car-radio. No manual! Found on this site a copy of the orginal English manual. I am very happy with it. Now I know how to setup and use my "new" car-radio.
Recommended site for everybody looking for a manual for (older) products!
CAMCORDER ATTACHMENT
1
EN
11
Before attachment, make sure the camcorder's power is off.
1. OPEN COVER
Slide the Multi connector cover (MULTI) on the bottom of the camcorder in the direction of the arrow until you hear a click.
2. ATTACH
Attach the camcorder by aligning the mark on it with the one on the Video Capture Docking Station.
3. FIX
2 3
Mark
Slide the camcorder in the direction of the arrow.
4. LOCK
While holding the camcorder, slide the LOCK lever in the direction of the arrow.
To remove the camcorder . . . � press the RELEASE button. After the LOCK lever has been released, detach the camcorder.
LOCK lever RELEASE button
Lock !
NOTE : If it is impossible to slide the lock lever, repeat steps 2 and 3.
Charging a battery Installed in the Camcorder . . .
If you attach the camcorder with a battery installed to the Video Capture Docking Station, you can charge the battery. First make sure that the camcorder does not have a DC cord connected to it before attaching. Turn the camcorder's Power Dial to "OFF" then perform the following steps. 1. Connect the Video Capture Docking Station to the AC Power Adapter/Charger. �The Video Capture Docking Station does not use the camcorder's battery to function. Be sure to connect the AC Power Adapter/Charger exclusively for use with the camcorder. 2. Connect the power cord to an AC outlet. �The Docking Station's charger indicator begins (CHARGE) blinking to indicate that the charge has begun. When it stops blinking and lights steadily, the charge is complete. It takes approx. 2 hours to charge the battery fully.
Charger indicator
Core filter
|
|
|
> |
|
