|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
 ;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
;
Great copy of the manual, has all information required for servicing,
Height diagram
C
60
C
D
30
D
� R. H. LOW Select this if the rear speakers are located in section D. � R. H. HIGH Select this if the rear speakers are located in section C. These parameters are not available when �REAR� is set to �NO�. To specify the balance and level of the speakers
1 2 3
Press AMP MENU repeatedly to display 9 LEVEL on the front panel display. Use X/x to select T.TONE and use C/c to set T.TONE to ON. You will hear the test tone from each speaker in sequence. Sit in your listening position and select the item to be adjusted using X/x. � Items adjusted in 9 LEVEL � Balance of the front and rear speakers � Volume level of the center and rear speakers and subwoofer Adjust the volume level so that the volume of the test tone from each speaker sounds the same using C/c. The adjusted value will appear on the front panel display. Repeat Steps 3 and 4 to adjust other parameters in 9 LEVEL. If you do not operate the remote for a few seconds, the value disappears from the display and is stored in the system. Use X/x to select T.TONE and use C/c to set T.TONE to OFF.
4 5 6
xBALANCE You can vary the balance of each speaker as follows. The default settings are underlined. � F. ___I___ center (front speakers) Adjust the balance between the front left and right speakers (You can adjust from center, 6 steps left or right). � R. ___I___ center (rear speakers) Adjust the balance between the rear left and right speakers (You can adjust from center, 6 steps left or right).
28GB
|
|
|
> |
|
