|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good quality. Some parts are not fully readable, but the fundamental ones are fine.
;
very good quality readable manual,printed off very well.
;
The manual was very accurate for the part that I was changing, I was able to order the correct part and had no issues with the replacement procedure. However, I was expecting to have more detailed repairs for the lower drive unit.
 ;
I needed the manual immediately and I got it immediately. I couldn't find this manual anywhere else on the net. The site was easy to traverse, and the price was very reasonable. I'll definitely be back for any future needs.
;
I received a good service manual, with good resolution. Improve the instructions for the purchase because they are not well understood.
For the rest, so good.
Thanks Angel.
Ver 1.3 2003.01
HCD-DP900D
DVD SECTION
When optical pick-up is exchanged, should make automatic servo adjustment by using the test disk.
Note :
3. Confirm that the S-Y level is 1.0 ± 0.1Vp-p.
1.0 ± 0.1 Vp-p
1. DVD Block is basically designed to operate without adjustment. Therefore, check each item in order given. 2. Use HLX-504 (J-6090-088-A) or HLX-505 (J-6090-089-A) unless otherwise indicated. 3. Use an oscilloscope with more than 10M� impedance. 4. Clean the object lens by an applicator with neutral detergent when the signal level is low than specified value with the following checks. Video Level Adjustment (MB BOARD) Purpose This adjustment is made to satisfy the NTSC standard, and if not adjusted correctly, the brightness will be too large or small.
4. Connect oscilloscope to S-VIDEO output. (S-C teminal) 5. Connect that the S-C burst is 286 ± 50mVp-p.
286 ± 80 mVp-p
Oscilloscope
75 �
set
Adjustment Location
J601 VIDEO OUTPUT
MB BOARD (SIDE A)
Procedure: 1. Connect oscilloscope to VIDEO output. 2. Load a disc (HLX-504 or HL-505) playback. 3. Adjust the RV501 to attain 1.0±0.1Vp-p.
CN011
1.0 ± 0.1 Vp-p
(WHITE 75%)
S-terminal Output Check Purpose Check S-video output.
RV501 VIDEO LEVEL Adjustment
IC103 IC503
CN008
Oscilloscope
CN404
CN103
set
G G
75 �
J602 S-VIDEO OUTPUT
Procedure: 1. Connect oscilloscope to S-VIDEO out. (S-Y teminal) 2. Load a disc (HLX-504 or HL-505) playback.
20
|
|
|
> |
|
