|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent copies.
I will use "Owner Manual" again a second time.
 ;
Very good manual for Technics SL 303. Manuale molto utile.
;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
HCD-DZ150K/DZ151KB
3-8. POWER BOARD
5 eight screws (+PWH 3 � 8) 1 connector 4p (CN3002)
Clamp the harnesses with a lead pin or a similar tool so that they do not touch this screw and the heatsink (AMP). heatsink (AMP) screw lead pin
9 POWER board
8 cover (PWB)
Attach the heat radiation sheets on the chassis, and then install the POWER board. radiation sheets
7 Remove the two claws in the direction of the arrow B.
B
A
harness
3 connector 12p (CN906)
6 Remove the POWER board and the cover (PWB) in the direction of the arrow A.
Attention at assembling POWER board.
Because of prevention of damage caused by creep of radiation sheets, outfit a power board with the set after fiting the cover (PWB) on the POWER board.
4 screw (+BV 3 � 6)
2 connector 2p (CN901)
3-9. SPEAKER BOARD, D.C. FAN
3 two screws (+BV 3 � 6)
7 D.C. fan 4 SPEAKER board
2 screw (+BVTP 3 � 8) 1 connector 8p (CN303) 5 connector 2p (CN3000)
6 two screws (+BVTT 4 � 8)
17
|
|
|
> |
|
