|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good quality, prompt response. This website has reasonable prices and wide range of manuals that are hard to find.
;
The document was usefull, and it was exactly what I was looking for.
;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
HCD-DZ7T
3-6. TUNER (FM/AM)
3 tuner (FM/AM)
2 wire (flat type) 9core
1 two screws (+BVTT 2.6 � 6)
3-7. POWER BOARD
1 connector 4p (CN3002)
5 eight screws
Clamp the harnesses with a lead pin or a similar tool so that they do not touch this screw and the heatsink (AMP). heatsink (AMP) lead pin
(+PWH 3 � 8)
9 POWER board
screw
8 cover (PWB)
Attach the heat radiation sheets on the chassis, and then install the POWER board. radiation sheets
7 Remove the two claws in the direction of the arrow B.
B
harness
A
3 connector 12p (CN906)
6 Remove the POWER board and the cover (PWB) in the direction of the arrow A.
Attention at assembling POWER board.
Because of prevention of damage caused by creep of radiation sheets, outfit a power board with the set after fitting the cover (PWB) on the POWER board.
4 screw (+BV 3 � 6)
2 connector
2p (CN901)
18
|
|
|
> |
|
