|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is wonderful done!!! a great job in scanning the manual. Superior quality in all the electric scheme. Very understandable and net!!! Thank you!
 ;
muy buen manual por lo completo de este algunos esquemas estan muy divididos lo que hace algo dificil el seguimiento.
;
very good manual, with detail and clarity in esquematic diagrams and waveforms .
;
Very quality copy of original service manual, which contains the circuit diagrams, PCB and lists of components, well as recommendation for calibration procedures of device, also everything else, that need for repair, tuning and use this oscilloscope.
All presented copies have high-resolution, so you can view all in detail.
This manual will very useful for simple owners and for repairers.
I recommend these manual, because myself is owner of Philips PM3216 and I need sometimes servicing these oscilloscope (principally calibrating).
Also, these document is an example of excellent design of technical documentation.
;
Excellent printing quality.
A complete and very usefull service manual with all details.
GREAT SERVICE AT VERY LOW PRICE!
A+++++++++++++++++++++++++
HCD-HPR90/HPR99XM
CD SERVICE MODE
This mode can run the CD sled motor freely. Use this mode, for instance, when cleaning the optical pick-up. Procedure: 1. Press the I/1 button to turn the power on. 2. Press the [CD] or [FUNCTION] key on the remote commander to select �CD�. 3. Press three buttons of [PUSH ENTER], [DSGX] and [DISC 1] simultaneously, the message �SERVICE IN� is displayed on the fluorescent indicator tube. 4. Press the M L button to move the optical pick-up to outside track and the message �SLED OUT� is displayed on the fluorescent indicator tube, or press the l m button to inside track and the message �SLED IN� is displayed on the fluorescent indicator tube. 5. Press the x button, �LD OFF� is displayed and laser diode is turned off. Each time x button is pressed, laser diode ON/ OFF switch is performed. 6. To release this mode, press the I/1 button.
TUNER STEP CHANGE-OVER
A step of AM tuning interval can be changed over between 9 kHz or 10 kHz. Procedure: 1. Press the I/1 button to turn the power on. 2. Press the [TUNER/BAND] button to select �AM�. 3. Press the I/1 button again to turn the power off. 4. Press two buttons of M L and I/1 simultaneously. 5. The message �STEP 9kHz� or �STEP 10kHz� is displayed on the fluorescent indicator tube and thus the tuning interval is changed over.
13
|
|
|
> |
|
