|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
 ;
This is a great and complete Service Manual for the Sharp GF8585HB. Giving full and detailed technical insight. Good to find these manuals online.
;
Everything was ok with the manual. If I have a small complaint, is that I ordered it during the weekend and I think you guys were closed. But I did receive it late Sunday. I will surely order from you again
HCD-LX10000
[VACS ON/OFF] � This mode is used to switch ON and OFF the VACS (Variable Attenuation Control System). Procedure: 1. Press ?/1 button to turn the set ON. 2. Press x button and [ILLUMINATION] button simultaneously. The message �VACS OFF� or �VACS ON� appears on the fluorescent indicator tube. [TUNER STEP CHANGE] � The step interval of AM channels can be toggled between 9 kHz and 10 kHz. Procedure: 1. Press ?/1 button to turn the set ON. 2. Press [TUNER/BAND] button repeatedly to select the �AM�. 3. Press ?/1 button to turn the set OFF. 4. Press [ENTER] button and ?/1 button simultaneously. The system will turn ON automatically. The message �AM 9k STEP� or AM 10k STEP� appears on the fluorescent indicator tube and thus the channel step is changed. [CD SERVICE MODE] � This mode let you move the CD sled motor freely. Use this mode when you want to clean the optical pick-up. Procedure: 1. Press ?/1 button to turn the set ON. 2. Select CD function. 3. Press x , [ENTER] button, and Z OPEN/CLOSE button simultaneously on the fluorescent indicator tube. 4. The CD service mode is activated. The message �SERVICE MODE� appears on the fluorescent indicator tube. 5. With the CD in stop status, turn m M knob clockwise to move the optical pick-up to outside track, or turn
[AGING MODE] This mode can be used for operation check of CD section. � If an error occurs, the aging operation would stops and the status is displayed. � If there were no error occurs, the aging operation would continues repeatedly. Procedure: 1. Press ?/1 button to turn the set ON 2. Select CD function. 3. Load three discs on the disc tray. 4. Press [PLAY MODE] button on the remote repeatedly to select the �ALL DISCS� mode, and press the [REPEAT] button on the remote repeatedly to select �REPEAT OFF� mode. 5. Press x button, [ENTER] button and [EX-CHANGE/DISC SKIP] button simultaneously. 6. Aging operation is started. 7. To release from this mode, press ?/1 button or disconnect the power cord to turn the power OFF. Aging mode sequence:
Start (from disc 1)
Disc chucking
TOC reading
Play first track for 2 seconds
Play last track for 2 seconds EX-CHANGE open/close
m M knob counter-clockwise to move to inside track.
The message �SLED OUT� or �SLED IN� appears on the fluorescent indicator tube. 6. To turn on or off the laser, press [DIRECTION] button. The message �LD ON� or �LD OFF� appears on the fluorescent indicator tube. 7. To release this mode, press ?/1 button.
Open the disc tray Disc skip
Close the disk tray
Change the next disc
18
|
|
|
> |
|
