|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
;
excellent value & price! Includes everything you need to know about the NN-C777! I would buy this again.
;
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
Energy saving tip
If you plan to be away from home more than two days, you may want to turn the temperature control to �OFF� to eliminate energy consumption during your absence. You will not save any energy by turning the dispenser off at night and back on the next morning.
Caring for your hot water dispenser
Winterizing
Be sure to safeguard your dispenser when it is exposed tank to prevent the water inside from freezing. Freezing to freezing temperatures. Drain the storage will ultimately damage the storage tank:
To Drain:
the power cord. 2. Turn Temperature Control Knob to �OFF.� 3. Run hot water dispenser until water is cold. 4. Place at least a 3-quart capacity container under the drain plug on the storage tank. 5. Unscrew the drain plug with a %a� wrench and allow all water to drain. 6. Replace and tighten the drain plug. Do not
overtighten. 1. Unplug TEMPERATURE CONTROL KNOB -
DRAIN PLUG \
When
ready
to use the dispenser
again,
see �Using your hot water dispenser.�
to the unit will result and is not covered
CAUTION: DO NOT TURN UNIT ON IF TANK IS EMPTY. Damage by the warranty
Cleaning the Spout Screen
If you have very hard water, it may be necessary to clean the Spout Screen occasionally
To Remove:
the two spout screws. 2. Remove spout base plate. 3. Pull the screen assembly out of the hot water tube.
1. Remove
To Clean:
1. Use a small brush and vinegarto
remove for
deposit 2. If deposit has hardened, soak in vinegar an hour or two. Then brush clean. 3. Replace screen assembly in tube and screw plate back onto spout.
|
|
|
> |
|
