Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
Text excerpt from page 15 (click to view)
Wall unit mounting - Fig. 7-8
� Assembling the chimney flue support/ bracket: The three parts should be fixed with 4 screws, the support extension is adjustable and should correspond to the
X
G
=
=
�
�
� � � �
� � � �
internal width of the telescopic chimney flue. Fig. 7. X Mark the wall with a centre line, this will aid mounting procedure (1), position the template so that the mid line printed on H the template matches with the centre line previously drawn, the lower side of the template corresponds to the lower side of the hood once mounted (2). Drill two holes � 8mm and fix the support bracket with two wall plugs and screws (3). The wall plugs, if supplied, are for Fig. 7 brick or solid block fixings only, excluding thermal blocks and similar. For mounting on any surface other than brick, the correct fixings must be used. Hang the hood (4) and adjust its position (5-6). From the inside of the hood mark two points for definitive fixing (7). Remove the hood (8) and drill two holes � 8mm (9), fit two wall plugs (10). Drill two holes � 8mm on the upper side close to the ceilling, fit two wall plugs (11) (In case the hood is to be used in recirculation mode, mount the deflector F on the chimney support with four screws 2,9x6,5 and fix the chimney support G with two screws (12). Hang the hood again (13) and fix it definitively with two screws (14). Fit an exhausting pipe (15) to connect the outlet hole A of the hood to the outside (Extractor hood) or to the deflector F (recirculation mode). Make electrical connection (16). Fix the chimney first up (17a) to the chimney support (17b), then slide the lower section of the chimney down into the proper housing on top of the hood (18).
