|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I have never bought a service manual which is as competely readable as this althogh it was a scanned pdf. Thank you for this succesful manual also cheaper than other sites.
;
Thanks for a very good and readable servicemanual. Just what I needed as a "dinosaur technician". I really recommmend this site and will come back.
Åsbjörn
;
The manual I purchased was just what I needed. I was glad to find a site where I can find so many manuals on a wide variety of products.
;
The best diagram that I used in a long time. Everything was right on te money. It was easy and fast. Iwoiuld but again when I need a service manual.
;
The manual is great help for me, i'm happy to have it,thanks
2-11. Replacement of Fan
2-11. Replacement of Fan
c If the fan is out of order, the inside temperature of the unit will rise. Touching the inside in this state may cause a burn. When replacing the fan, allow a few minute after powering off until the inside cools off. 1. Perform the procedures 1 to 3 in Section 2-7-2 to remove the CCD unit. 2. Remove the seven screws to remove the V shoe bracket.
4. Remove the four screws to remove the fan.
Fan
B2.6 x 20
Harness
B2.6 x 20 Label
Bracket
5. Install a new fan in the reverse order of removal.
B3 x 5
[Notes|at|installation] . Install the fan to the bracket with care so that the label faces the bracket and the fan harness is routed as shown in the above figure. . Insure a proper fit between the fan bracket and chassis as shown in the figure below.
Fan bracket
V shoe bracket
K3 x 8 B3 x 5
3. Remove the two screws. Disconnect the harness from the SW-688 board.
Fan bracket
B2.6 x 4
HDC-750A
2-13 (E)
|
|
|
> |
|
