|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Dear Sirs,
Thank you for the fast support, the manual does provide all necessary information to repair the radio. All schematics are in a good quality for reading.
The manual fits 100% to my requirements as a technican.
Kind regards Thomas
;
the big video recorder format s-vhs many features delicate in loading system of the cassette. Such machines are no longer manufactured, it would be too expensive.
 ;
THIS MANUAL IS VERY GOOD AND VERY CLEAR
PLEASE NOTE IT DOES NOT CONTAIN THE SETUP INFORMATION TO ALIGHN THE GEARS IN THE CD MECH IT DOES SHOW ALL THE PARTS AND THEIR LOCATIONS .
;
Complete service and operation manual. All schematics are there, all circuit boards AND add-on boards. Including exploded views ,component names and specifications. Also electrical and mechanical adjustment procedures are in this manual. This manual also covers the more advanced BR-S811E unit. Scan quality is fair and usable.
;
High quality scan of original Service Manual. Everything´s fine!
4-2-10. PG Phase Adjustment
4-2-10. PG Phase Adjustment
Tools . Alignment tape, HR2-1A Setting 1. Turn the power on. 2. Load the alignment tape HR2-1A. Adjustment 1. Setting the adjustment mode (1) Set dip switch S1-1 of the HN-243 board to ON. (2) Press the S3 switch on the HN-243 board two times. (Within 1 second/time) Check to see that the MODE display LED lights up. 2. Executing automatic adjustment (1) Set the first 10-minute portion of the alignment tape HR2-1A in PLAY mode. n Never use portions after the first 15 minutes of the alignment tape. (2) Turn the tracking volume (RV1) of the HN243 board fully clockwise. (3) Press the S2 switch of the HN-243 board for more than 1 second. This sets the automatic adjustment mode. (4) After several seconds, make sure that the alignment tape HR2-1A is ejected automatically. If it is, it means that automatic adjustment has been executed and completed correctly. If the STOP mode is set, repeat steps 1 to 3 again. If the STOP mode is set again, perform PG phase adjustment in the manual mode. 3. Exiting the adjustment mode Set dip switch S1-1 of the HN-243 board to OFF. : 8-960-076-11
4-42
HDW-700E MMP2V1
|
|
|
> |
|
