PHILIPS HI556/22
Owner's Manual

- Put the iron back on its stand. Let it heat up again until the amber pilot light goes out. - Remove the iron from the stand and move it over a (preferably) old piece of cloth. This is to ensure that the soleplate will be dry during storage. - Unplug and allow the iron to cool down before storing it on the stand. Cleaning - Before cleaning remove the mains plug from the wall socket and allow the iron to cool down sufficiently. - Scale and other setting can be wiped off the soleplate with a damp cloth and some nonscratching (fluid) abrasive. Keep the soleplate smooth: avoid hard contact with metal objects. - The upper part of the appliance can be cleaned with a damp cloth. - From time to time clean the inside of the water reservoir by filling with water and shaking. Then pour the water back out. Storage � Always store the iron on the stand to prevent damage to the soleplate. - Remove the mains plug from the wall socket.

30

31

- Set the 3-positions switch to the storage position - (fig. 30). The iron, the power unit and the stand are then locked together. - You can wind the cord around the stand. With the cord clip you can fix the end of the cord (fig. 31).

32

33

- Unlock the stand clamp (S) (fig. 32). - Screw in the fixing screw completely (fig. 33).

34

35

27

28

CL

IC

K

- Set the steam control 29 (B) to position O (= no steam). - Set the 3-positions switch to position � (fig. 27). - Take the iron from the stand. Open the filling funnel and pour the remainder of the water out (fig. 28). - Place the iron back on the stand to cool down (fig. 29).

- Fold the stand clamp into the stand (fig. 34). - (Types HI 556/66 only:) First allow the iron to cool down. Then place the carry case over the stand. Press onto the case to lock it to the stand (�Click!�) (fig. 35).

9