|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
;
Service Manual that I received was very helpful to me. Thank you.
;
The manual is well organized and is easy to read. The chapters are following normal way to proceed.
;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
1-3. Replacing CCD Unit
1-3-4. Positioning Adjustment for Filter Knobs
Installing the filter knobs, be sure to perform the following adjustment. 1. Rotate the outer knob shaft until the cross filter can be seen from the lens mount. 2. Align the CC filter knob number A with the mark on the front panel and tighten the two setscrews. Tightening torque: 20 x 10_2 N.m (2.0 kgf.cm) 3. Rotate the CC filter knob and check that it moves smoothly. 4. Rotate the inner knob shaft until the clear filter (straight through filter) can be seen from the lens mount. 5. Align the ND filter knob number 1 with the mark on the front panel and tighten the two setscrews. Tightening torque: 20 x 10_2 N.m (2.0 kgf.cm) 6. Rotate the ND filter knob and check that it moves smoothly.
Setscrews (WP2 x 3) Setscrews (WP2 x 3)
Mark
1-6 (E)
HKC-7081
|
|
|
> |
|
