|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good condition and quality. Hard to find anywhere in Internet, only on this site.
 ;
Exactly what I needed to be able to bring the amp back to life... will come back to this site the next time I need schematics.
;
Information was accurate and very helpful.
However the continuity made it a little difficult to follow from one page to the next.
;
Very very good as usual very trustable site. Perfect!!!!!!
;
The Service Manual received was helpful. Good copy of original document.. I recomend all of my friends about this technical page.
Section 1 Attachment
1-1. Supplied Accessories
The supplied accessories of HKPF-106 are as follows: . Label :1 . Maintenance manual : 1 . Operation manual :1 3. Insert the board along the board guide rail.
1-2. Board Attachment
. This section is described how to attach the board in PFVHD300. For how to attach it in models other than PFVHD300, refer to the manual supplied for each model. . Insert the board in any blank slot of PFV-HD300. n Do not insert the board in the slot No. 14. Front panel 1. Loosen the four screws (with stopper) and detach the front panel. 2. Unscrew the six screws and detach the board supports. 4. Insert the board in the slot as far as it will go and close the two board levers in the directions of arrows 1.
Board guide rail
Board Put the component side so that it is viewed at the right.
1
2
2 1 Board lever 1 PSW 3x6 2 Board lever 1Attachment 2Detachment 1 2
PSW 3x6
Board supports
5. Put the supplied label onto the two board levers. 6. Attach the board supports. 7. Attach the front panel. n When detaching the board, pull out the board toward you while pushing the two board levers in the directions of arrows 2.
HKPF-106
1-1 (E)
|
|
|
> |
|
