|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good site, works ok and you get what you order, no problems experienced, got my manual within a day. A++++
 ;
Original well scanned manual. Got the job done. Microwave problem found & corrected. For $5 and a new magnitron from ebay, it was a cheap and good the first shot fix. Electrical schematics allowed me to mage sure every thing else was ok before cutting and order for parts. Hard to live without.
;
I was very skeptical of this website, I have never downloaded manuals before. I put it on the AMEX and payed through Paypal to ensure protection. I got the manual exactly as described and now I can replace the filter capacitor for this amp. Great Price, others selling for 12.99 or more and this is the same manual. I will search out this website for other manuals. Thank you
;
Manual was reasonably easy to follow. I am not an engineer or know much about electronics but with the manuals help I was able to figure out the problem, identify the part required for the repair. Replacement part cost around $30. Whilst replacing the part I was telling myself, "this aint gonna work cos it seems far too easy". Took about 15 minutes to do and my plasma TV works a treat. Would never have been able to do this without the service manual.
;
It is OK, this manual help me to repair my dynacord
1-3. Board Attachment
1-3. Board Attachment
. This section is described how to attach the board in PFVHD300. For how to attach it in models other than PFVHD300, refer to the manual supplied for each model. . Insert the board in any blank slot of PFV-HD300. n Do not insert the board in the slot No. 14. The maximum two HKPF-1125s can be attached in the PFV-HD50A. The maximum seven HKPF-1125s can be attached in the PFV-HD300 when the only HFPF-1125 will be used. Front panel 1. Loosen the four screws (with stopper) and detach the front panel. 2. Unscrew the six screws and detach the board supports.
3. Insert the board along the board guide rail.
Board guide rail
Board
Put the component side so that it is viewed from the right side.
4. Insert the board in the slot as far as it will go and close the two board levers in the directions of arrows 1.
1
2
2 PSW3 x 6 1 Board lever 1 PSW3 x 6 Board supports 2 Board lever 1Attachment 2Detachment 1 2
5. Put the supplied label onto the board lever. 6. Attach the board supports. 7. Attach the front panel. n When detaching the board, pull out the board toward you while pushing the two board levers in the directions of arrows 2.
1-6 (E)
HKPF-1125 MM
|
|
|
> |
|
