|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
;
Service Manual that I received was very helpful to me. Thank you.
;
The manual is well organized and is easy to read. The chapters are following normal way to proceed.
;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
;
Very useful service manual, was exactly what i needed.Good quality,reasonable price.Thank you.
Section 1 Attachment
1-1. Supplied Accessories
The supplied accessories of HKPF-E270 are as follows. . Label :1 . Maintenance manual : 1 . Operation manual :1 3. Insert the board along the board guide rail.
1-2. Board Attachment
. This section is described how to attach the board in PFVHD300. For how to attach it in models other than PFVHD300, refer to the manual supplied for each model. . Insert the board in any blank slot of PFV-HD300. n Do not insert the board in the slot No. 14. Front panel 1. Loosen the four screws (with stopper) and detach the front panel. 2. Unscrew the six screws and detach the board supports. 4. Insert the board in the slot as far as it will go and close the two board levers in the directions of arrows 1.
Board guide rail
Board
Put the component side so that it is viewed from the right side.
1
2
2 1 Board lever 1 PSW3 x 6 2 Board lever 1Attachment 2Detachment 1 2
PSW3 x 6
Board supports
5. Put the supplied label onto the board lever. 6. Attach the board supports. 7. Attach the front panel. n When detaching the board, pull out the board toward you while pushing the two board levers in the directions of arrows 2.
HKPF-E270 MM
1-1 (E)
|
|
|
> |
|
