|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
very helpfull
circuit diagram and sparepart list available
 ;
Very good reproduction (copy) of original manual. Didn't have a parts list, but schematic was completely labeled with parts. Complete instructions on how to adjust mechanical functions of the 8-track deck. Well worth having and at a very reasonable cost.
;
It's a full manual. All the parts are in there. I haven't found the problem yett, but I am working on it; hope I can rebuild the part myself. To make it more secure and unbreakable this time. Because the part has failed several times before and costs a lot to let it be repaired.
Thanks so much for this rich illustrated and parted manual.
;
I downloaded the document. The manual was complete, well scanned and everything was legible. I could zoom in see what I needed to know. There's not much more that you can ask.
;
It was complete service manual with all needed service informations. Thanks.
1.28
Fixing unit (for both 115V and 230V, the only difference is the Halogen heater) (The fixing unit can be disassembled even after removing the Rear cover ASSY in section 1.6). (1) Release the hook of the heater lead wire connector (2P) by pinching the connector and pull it out upward (to remove it from the low-voltage power supply ASSY). (2) Pull out the Fixing PCB connector (4P) to the rear ( A ). (3) Loosen the 2 screws which are securing from the rear, and remove the fixing unit by pulling it to the rear.
Heater lead wire
A
Connector (2P) Connector (4P)
Screw Fixing unit
Screw
Figure 4.49 (4) Take off the Halogen heater by removing 2 screws at the both side, remove the Halogen heater.
Halogen heater Screw Fixing unit cover
Figure 4.50
Note:
Do not use the electric driver as the Halogen heater is easy to break. Do not touch the Halogen heater glass. If finger prints are on it, clean it with a cloth dampen with iPA alcohol. When reassembling, make sure; - The terminal of the heater lead wire connector (2P) should be placed over the terminal of the Halogen heater. - The wire bridge between the Halogen heater and its terminal must be up.
IV-24
|
|
|
> |
|
