|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual I purchased was just what I needed. I was glad to find a site where I can find so many manuals on a wide variety of products.
;
The best diagram that I used in a long time. Everything was right on te money. It was easy and fast. Iwoiuld but again when I need a service manual.
;
The manual is great help for me, i'm happy to have it,thanks
 ;
Very pleased with manual except that a few more details in the drawings might make the job (not yet done, tut-tut) easier. Should be adequate though. Actually I didn't have to pay for this anyway as I was given credit for another item that wasn't quite complete. Good service, then.
;
Very useful manuals, somewhere graphics not very clear!
(7) CDCC parallel I/O <Data receiving> There are two modes in this unit. One is the CPU receiving mode and the other is the DMA receiving mode. In the CPU receiving mode the CPU receives the command data from the PC, and after the CPU is switched to the DMA mode, it receives the image data and writes to the DRAM directly. CPU Receiving Mode
STROBE
BUSY ACK 90 µsec 0.5 µsec
STROBE
BUSY ACK 1.5 µsec 0.5 µsec
BUSY goes HIGH at the falling edge of STROBE. The data (8 bits) from the PC is latched in the data buffer at the rising edge of STROBE. The pulse width of ACK differs according to the speed MODE as shown above. BUSY goes LOW at the rising edge of ACK. <IEEE1284 support> This supports the IEEE1284 data transfer with the following mode. Nibble mode Byte mode (8) Data extension This circuit extents the compressed image data which are received from the PC, and writes the bit map data to the FIFO. (9) Software support Supports 16 x 16 rotation, bit expansion, and bit search. (10)EEPROM I/O One output port and one I/O port are assigned.
II-11
|
|
|
> |
|
