WHIRLPOOL HOO 502 W
Quick Start

HOO 502 - 512 - 546 PRODUCT DESCRIPTION SHEET
CONTROL PANEL
A. Light switch. B. Speed selector.

1 4 2 3
1. Control panel 2. Grease filters (inside the extraction grille) 3. Lighting unit 4. Pull-out steam deflector small amount of steam and fumes large amount of steam and fumes medium amount of steam and fumes
O123 O

A

B

REMOVING AND RENEWING OR CLEANING GREASE FILTER:
1. Unplug the appliance or switch off the mains power supply. 2. Pull out the steam deflector. 3. Remove the extraction grille. 4. Remove the grease filter fixing device. 5. Remove the dirty grease filter. 6. After renewing the grease filter (depending on model) remount in reverse order, making sure the entire extraction surface is covered.

CLOSED
CLOSED

OPEN

MOUNTING OR RENEWING THE CARBON FILTER:
1. Unplug the appliance or switch off the mains power supply. 2. Pull out the steam deflector. 3. Remove the extraction grilles. 4. If a carbon filter is already mounted and needs renewing, press the release buttons (b) and pull the filter out downwards. 5. If the filters are not mounted. a. Fit the carbon filter onto the upper hooks. b. lock using the lower hooks. 6. Remount the extractor grille.

a

REPLACING BULBS:
1. Unplug the appliance or switch off the mains power supply. 2. Pull out the steam deflector. 3. Open the rear extraction grille. 4. Remove the burnt-out bulb. Use 40W max (E14) bulbs only. 5. Remount the extractor grille.

b
I GR S DK N FIN
LI01TA

D
5019 100 75008/A

GB

F

NL

E

P



OPEN