|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
 ;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
;
Fast and courteous service. Product delivered as described. Thank you.
;
Last week I bought a second hand Panasonic AG-7500 SVHS Hi-Fi Video Cassette Recorder. It is a professional machine with many video and audio options. I feared it would be a huge quest to find a manual. I was delighted when I found owner-manuals.com. After payment I received the file to download the next day already. The quality is great. I am very happy. Thanks!
;
The owner's manual/operating instructions that I purchased was the original factory document and it was in at least three and maybe more languages. I no longer have it because I sold the tape recorder and included the owner's manual/operating instructions and a service/repair manual that I bought on ebay for the new owner.
INSTALLATION
Setting up the saw carriage
!
WARNING! The saw carriage is heavy. Two persons are needed to handle it.
NOTE! Do not place the saw carriage on the rails or any other hard surface too hastily. This can cause permanent damage to the saw carriage bearings. NOTE! Do not place the saw carriage directly on the ground where dirt and impurities can come in contact with the saw carriage wheels. Place the saw carriage onto the rails, and position it by carrying out the following: 1. Arrange for two persons, one on each side, to take hold of the saw carriage. Lift the saw carriage as follows: Right side: At the crank for band tensioning and under the blade wheel guard. Left side: At the motor bar and the blade wheel guard. 2. Lift the saw carriage and lower it carefully on the rails. The grooved rim of the wheels at the base of the carriage must fit over and rest on the rails.
To adjust the position of the saw carriage
The position of the saw carriage on the rails can be adjusted when the guide wheels and rail guards are mounted. The purpose of the guide wheels (bearings) is to retain the saw carriage on the rails and to prevent it from tilting. The rail guards are designed to keep the rails and the saw carriage wheels free of dirt and the like. The following parts must be mounted on the saw carriage: � Two guide wheels (bearings) � Four saw carriage rail guards. To mount them, proceed as follows: 1. Fit the guide wheel mounting bracket in position by means of screws. Hold a 0,2 mm thick feeler gauge between the guide wheel and the rail. 2. Press the guide wheel upward against the rail and tighten screws of the guide wheel mounting bracket to secure it in position. Tightening torque: 40-50 Nm. Then remove the feeler gauge. 3. Repeat steps 1-2 above when fitting the other guide wheel. 4. Fit the four rail guards over each grooved-rim wheel.
English
19
|
|
|
> |
|
