|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
LE
MASTER
67
REVERB
67
PRESENCE PREAMP POWER
67
OUT
FOOT AMP IN SWITCH
ON
ON
8 9 10 11 4 3 2
5
8 94 10 3 11 2
5
8 94 10 3 11 2
5
8 9 10 11
12
CHANNEL SELECT
1
12
1
12
1
12
STANDBY
OFF
K
L
M
N
O
P
Q
R
S
T
K. CHANNEL SELECT - When this button is pressed, the amp switches from the NORMAL channel to the DRIVE channel. L. MASTER - Adjusts the overall volume of the DRIVE channel . M. REVERB - Adjusts the amount of reverb present in both the NORMAL and DRIVE Channels. N. PRESENCE - Adjusts the amount of very high frequencies present in both the NORMAL and DRIVE Channels. O. PREAMP OUT - This unbalanced jack provides an output signal from the preamp and is pre-reverb. It may be used to drive effects units in an effects loop, to drive additional amplifiers in a multi-amp set up, or as a preamp send to a mixing console. P. POWER AMP IN - This unbalanced jack provides a return from your effects units and is pre-reverb. This jack can also be used as a power amp input.
Q. FOOTSWITCH (INCLUDED) - Plug-in connection for the remote footswitch to select between the NORMAL and DRIVE channels and to select "More Drive". Using the footswitch overrides the front panel select buttons. NOTE: Any good quality patch cord will work with the remote footswitch, however, a speaker grade cord is preferable to a coax guitar cord. R. PILOT JEWEL - Illuminates if the Hot Rod Deluxe is receiving power. Should this bulb burn out, turn off and unplug the amplifier, unscrew the red jewel and replace the lamp with a type T47 bulb. S. STANDBY SWITCH - Turns the amplifier on and off. In the STANDBY position, the amplifier is off. When the "On/Off" switch (item T) is turned on, power is supplied to the tube filaments eliminating warm-up time. Using the STANDBY SWITCH during short breaks versus using the on/off switch will increase tube life. T. POWER SWITCH - Turns the AC power ON and OFF. When the amplifier is in the OFF position, the amplifier is completely shut down.
7
|
|
|
> |
|
