PHILIPS HP4607/10
Owner's Manual

8

ENGLISH

4 Release the lever (fig. 2). 5 Slide the barrel to the end of the lock (fig. 3). 6 Wind the hair round the barrel. Make sure the end of the lock is wound in the required direction (fig. 4). 7 Keep the curling iron in your hair for approximately 15 seconds (fig. 5). 8 Unwind the lock of hair until the clip can be opened again by means of the lever (fig. 6). 9 You can comb the curls with your fingers to add volume. Styling with the round brush The round brush can be used to create waves and to add volume to your hair. Prevent the brush from getting tangled in the hair in the following way: - Do not put too much hair in one lock. - Do not wind a lock of hair more than twice round the brush. - When unwinding a lock of hair, make sure that you hold the brush away from the underlying hair. 1 Slide the round brush onto the appliance (fig. 7). Be careful! If you have just used the curling iron, the barrel will still be hot. 2 Insert the mains plug into the wall socket. The pilot light goes on and the barrel starts heating up. The pilot light stays on as long as the appliance is connected to the wall socket. � After approximately 15 minutes the appliance is ready for use. 3 Start styling when the ready dot on the barrel changes colour. 4 Take a lock of hair and wind it round the brush. Make sure the end of the lock is wound in the required direction (fig. 8).