|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent copies.
I will use "Owner Manual" again a second time.
 ;
Very good manual for Technics SL 303. Manuale molto utile.
;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
SERVICE INSTRUCTION FOR PRINT-ASSY HR 2831/33 HR 2833 � turn the poti-gear to the MAX. left position. � mount the print-plate in the housing. � turn the speed-knob to the most right position for one time; the poti-gear is now right position. HR 2831 � turn the poti-gear to the MAX. left position. � remove the poti-gear. � mount the print-plate in the housing. � turn the speed-knob to pos. 2 put a screw driver to trim the speed to 1250 rpm.
MAX
poti-gear
SERVICE INSTRUCTION FOR REMOVING THE PULSE KNOB 1. put the speed knob to the most left position. 2. take a small screw driver and press it between speed knob and pulse knob.
3. turn the screw driver to pull the knob a little bit out of the power unit (a), set the screw driver deeper into the created hole (b) and lift it (c).
4. pull the pulse knob out of the speed knob.
b a c
|
|
|
> |
|
|
Parse Time: 0.246 - Number of Queries: 134 - Query Time: 0.055
