JVC HR-FS1U
Owner's Manual

� Playback �

Playing back tape repeatedly (100 times) � Repeat Play
During playback, press and hold PLAY (4) for more than 5 seconds. The �PLAY� display on the on-screen display starts blinking. To stop playback, press STOP (8) on the Remote or STOP/EJECT (0) on the VCR.

Recording
It may be unlawful to record or play back copyrighted material without the consent of the copyright owner.

Accidental erasure prevention
To prevent accidental recording on a recorded cassette, remove its record safety tab. To record on it later, cover the hole with adhesive tape.

Locating beginning of recordings � Index Search
Index codes are placed on the tape at the beginning of each recording when recording on this VCR.

Record safety tab

Basic Recording
A Load a cassette
Make sure the record safety tab is intact. If not, cover the hole with adhesive tape before inserting the cassette. � The VCR turns on, and the counter is reset, automatically.

A While the tape is not running, press SHUTTLE PLUS 2 or B To access a recording of 2 to 9 index
6 on the Remote to start search.
codes away, press 2 or 6 repeatedly until the correct number is displayed on the screen (only if �SUPERIMPOSE� is set to �ON�). Playback begins automatically when the desired recording is located. Beginning of the current program recorded Previous program recorded Current position on the tape Next program recorded

INDEX 1

B Select recording channel
On the Remote Press CH+/� or the Number keys. On the VCR Press PAUSE[CH]. The channel display on the display panel starts blinking. While the display is blinking, press FF[CH+] or REW[CH�] to select channel. After about 5 seconds, the channel display stops blinking.

Beginning of the 2nd next program recorded 2nd next

NOTES:

� You can select channel in the stop mode, recording pause mode or during rewind/fastforward high-speed search. � If no cassette is loaded, or during recording pause mode, you can select channel only by pressing FF[CH+] or REW[CH�]. � If you connect the TV and the VCR only using the RF connection, press TV/VCR on the Remote so that the VCR mode indicator lights on the display panel, to view the program to be recorded.

Locating beginning of timer recordings � Instant Review
After ensuring that the VCR is turned off and that the timer mode is disengaged, press REVIEW on the Remote. � The VCR turns on, and rewinds to the index code indicating the beginning of the last timer-recorded program, then begins playback automatically. � You can access a program of 2 to 9 index codes away from the current position on the tape. If, for example, you have 5 programs recorded and you want to watch the third one, press REVIEW three times. � The Instant Review function will also operate if the VCR is turned on.

C Set tape speed
Press SP/EP.

D Start recording
On the VCR, press REC (7). Or on the Remote, while holding REC (7), press PLAY (4).

During recording
Pause recording Press PAUSE (9). � Press PLAY (4) to resume recording. � You can select channel in the recording pause mode. Stop recording Press STOP (8) on the Remote. OR Press STOP/EJECT (0) on the VCR.

Skipping unwanted portions � Skip Search
Press SKIP SEARCH on the Remote 1 to 4 times during playback. Each press initiates a 30-second period of high speed playback (up to 2 minutes). When the specified portion of the tape is skipped, normal playback resumes automatically. To return to normal playback during Skip Search, press PLAY (4).