|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
EN
NOTES:
17
1 4
2 5 8 0
3 6 9
4
� You can programme this recorder to timer-record as many as 8 programmes. If you try to programme the recorder to record a ninth, "PROGRAM FULL" appears on screen. To record the extra programme, you must first cancel any unnecessary programmes ( pg. 21, "Check And Cancel Programmes"). � In case of a power failure after programming, the recorder�s memory backup keeps your selections (if the lithium battery is not exhausted).
NUMBER
7/
ATTENTION
Regarding Guide Program Number Set
"ERROR=GUIDE PROG" appears after performing step 3 on the previous page if the Guide Program number for the G-CODE number you entered has not been set. � If the recorder is in the stop or rewind or fast-forward mode, the following screen will appear with "� �" under "TV PROG" blinking. � Press the NUMBER keys or PUSH JOG %� to input the channel position number you recorder receives that station on, then press OK.
PUSH JOG
G-CODE SET-UP GUIDE PROG 2 TV PROG ��
2
1 ¶
1
3 7
4
¡ 8
¢
MENU
3
OK
(Ex.) To timer-record a SBS programme with G-CODE * If your recorder receives SBS on the channel position 2, press OK after entering "2".
[0-9] OR [5/�] : SELECT = [MENU] : EXIT
� Press MENU, then try again from step 1. � If the recorder is in a mode other than the above mentioned modes, press MENU first and input the correct Guide Program number for that G-CODE number ( pg. 14, "G-CODE Setup"), then try again from step 1.
|
|
|
> |
|
