JVC HR-J768EU
Owner's Manual

EN

25

1 4
VPS/PDC

2 5 8 0

3
D A I L Y

4 5
2

SET TAPE SPEED
Press SP/LP ( ) to set the tape speed.

SET VPS/PDC MODE
Press VPS/PDC to select "ON" or "OFF". If "VPS/PDC ON" is displayed on the screen or "VPS/ PDC" is lit on the display panel, VPS/PDC is set to ON. If "VPS/PDC OFF" is displayed on the screen or "VPS/PDC" is not lit on the display panel, VPS/PDC is set to OFF. "VPS/PDC Recording" on page 27.

6 9

P P / L S

7

WEEKLY

RETURN TO NORMAL SCREEN

4

6
STOP+/� PROG
1
?

Press PROG or OK. "PROGRAM COMPLETED" appears on the screen for about 5 seconds, then normal screen appears. � Repeat steps 1 � 6 for each additional programme.

ENGAGE RECORDER�S TIMER MODE

7
3

Press � (TIMER). The recorder turns off automatically and � appears on the display panel. � To disengage the timer, press � (TIMER) again.

OK

NOTES:

Satellite Tuner Users
To timer-record a satellite broadcast using SHOWVIEW: 1 Set "AV2 SELECT" to "AV2" ( pg. 33). 2 Perform steps 1 � 7. 3 Set the satellite tuner to the appropriate channel before the selected programme begins. 4 Leave the satellite tuner's power on.

� To Change The Stop Time . . . . . . press STOP +/� after pressing OK in step 3. You can compensate for anticipated programme schedule delays this way. � To Timer-Record Weekly Or Daily Serials . . . . . . after pressing OK in step 3, press WEEKLY (NUMBER key �9�) for weekly serials or DAILY (NUMBER key �8�) for daily serials (Monday � Friday). Either "WEEKLY" or "DAILY" appears on the screen. Pressing the button again makes the corresponding indication disappear. � You can programme this recorder to timer-record as many as 8 programmes. If you try to programme the recorder to record a ninth, "PROGRAM FULL" appears on screen and "FULL" appears on the front display panel. To record the extra programme, you must first cancel any unnecessary programmes ( pg. 28). � It is not possible to timer-record a TV programme with a SHOWVIEW number which starts with "0".

Timer Warning
ATTENTION
Regarding Guide Program Number Set
"GUIDE PROG SET" appears after performing step 3 if the Guide Program number for the SHOWVIEW number you entered has not been set. � Press the NUMBER keys or %� to input the channel position number on which your recorder receives that station, then press OK or # to set the Guide Program number. The SHOWVIEW program screen appears.
GUIDE PROG SET

If you have programmed your recorder to timer-record a programme or a series of programmes, a warning appears on screen to tell you that the recording is to start in 5 minutes.

� WARNING� TIMER RECORDING TO START SOON []

NOTES:
� The warning only appears if you�re not in the Timer mode at that time. � If this recorder is being used as the player for tape dubbing, the warning screen is recorded on the tape in the other video recorder. The warning blinks for the entire 5 minutes leading up to the start of timer recording. To clear the display, press .

GUIDE PROG 2

TV PROG ��

[5�] = [PROG] : EXIT

(Ex.) To timer-record a ZDF programme with SHOWVIEW. * If your recorder receives ZDF on the channel position 2, press OK or # after entering "2".