|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great product, helped me to restore vintage walkman cassette.
Just some pictures could be little bit more sharp and contrast
Thank you
;
I love older radio's and the service manuals that are sometimes hard to find. Was able to find a manual quite easily on this site.
;
Thank you for your shop manual! Your help was very useful - the device is repaired! Once again - Thank you! I wish you a successful business! Edward (Russia).
;
It was a great experience,instead of purchasing a new Stereo Amplifier ,in just minutes i repaired my old one and that was thaks to the manual I have purchased from you.
Thanks again.
Samuel Alter
;
Das ging ja sehr unkompliziert hat bestens geklappt und die Quallität ist auch noch gut.
Vielen Dank dafür.
TX-DS494/HT-R490 CONFIRMATION
CONFIRMATION OF PROTECTION CIRCUIT
1. Confirmation of speaker relay
Confirm that the speaker relay turns ON approximate 5 seconds after the power switch is turned ON. Confirm that the speaker relay turns OFF immediately after the power switch is turned OFF.
2. Confirmation of DC detection circuit
1. Press and hold down CD button, then press SPEAKERS A and SPEAKERS B buttons at the same time. 2. Press DVD button, while "TEST-1_" on the FLtube is displayed. During "TEST-1-00" on the FL tube is displayed. 3. Press SPEAKERS A button button During "TEST-1-01" on the FL tube is displayed. 4. Apply DC 1.5 3V to MULTI CHANNEL INPUT terminals with no load. Confirm that the speaker relay turns OFF. 5. Apply DC -1.5 3V to MULTI CHANNEL INPUT terminals with no load. Confirm that the speaker relay turns OFF.
3. Confirmation of Current detection circuit
1. Press and hold down CD button, then press SPEAKERS A and SPEAKERS B buttons at the same time. 2. Press DVD button, while "TEST-1_" on the FLtube is displayed. During "TEST-1-00" on the FL tube is displayed. 3. Press SPEAKERS A button button During "TEST-1-01" on the FL tube is displayed. 4. Connect Differentiator below and apply the 50Hz square signal to the MULTI CHANNEL INPUT terminals. 5. Adjust the attenuator or Volume so that the output level becomes 35V p-p. 6. Confirm that the speaker relay does not turn OFF when a 3.0 ohm load is connected. 7. Confirm that the speaker relay turns OFF when a 1.0 ohm load is connected.
AF Oscillator Differentiator 50Hz Square wave Oscilloscope 3.3k Input 10k GND 0.1 F 1SS133 3.3k Output 0.01 F GND 35Vp-p Attenuator CD Terminal Unit Speaker terminal Load
Differentiator
|
|
|
> |
|
