|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
30 EN
TIMER RECORDING (cont.)
You can programme a timer recording that starts within 24 hours using the JOG dial on the recorder.
24 Hour Express Timer Programming
Before performing the 24 Hour Express Timer Programming:
� Make sure that the recorder�s built-in clock is set properly. � Insert a cassette with the safety tab in place. The recorder will come on automatically. � Set the tape speed.
A Enter the programme mode.
Press 24H EXPRESS # on the recorder. The start time indicator ( ) starts blinking on the front display panel.
� The current tape speed and VPS/PDC setting appear on the front display panel, but it is impossible to change the setting. You can only change the setting after programming ( pg. 31).
B Set the programme start/stop time and
channel.
Turn the JOG dial to the left or right to set the time you want recording to start.
� One click stop of the JOG dial changes the time in 5-minute intervals.
Push the JOG dial. The stop time indicator ( ) starts blinking on the front display panel. Turn the JOG dial to the left or right to set the time you want recording to stop.
Push the JOG dial. Turn the JOG dial to the left or right to select the channel you wish to record.
� You can cancel the setting at any time by pressing and holding the JOG dial for more than 3 seconds or pressing & on the remote control. Repeat the step 2.
NOTES:
� You can programme this recorder to timer-record as many as 8 programmes. If you try to programme the recorder to record a ninth, �FULL� appears on the front display panel. To record the extra programme, you must first cancel any unnecessary programmes ( pg. 31). � It is not possible to timer-record a satellite broadcast received on the channel position �0� by the satellite receiver. � If �Err� appears on the front display panel, repeat the above steps again. � When a menu screen is shown, you cannot use 24 Hour Express Timer Programming function. Press MENU to return to normal screen, and try again. � You can use 24 Hour Express Timer Programming function also when the recorder is turned off. � For 24 Hour Express Timer Programming function, the programme overlap warning display does not appear even if some programmes overlap each other. The programme with the lower programme number will be recorded and the other one will not be recorded correctly.
C Engage the recorder�s timer mode.
Press 24H EXPRESS #. The recorder turns off automatically and �#� appears on the front display panel.
� To disengage the timer mode, press # (TIMER) or 24H EXPRESS # again.
|
|
|
> |
|
