|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I am very happy regarding the online purchase of this manual from Owner-Manuals.com as with this I could set right my Denon CD player and Amplifier.
I once again sincerely thank them for the prompt service which was rendered to me.
N. Shanker
;
More than pleased with my prurchase, very good product for the price.
;
Manual-link came 30 minutes after having paid for an extremely rare (40 years old) item (sony icr-120) and helped me to get the radio rework again. So really good help for me, fast and reliable delivery and -taken that into consideration- a very reasonable price for that service. So thanks again! Mike, Germany
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
SECTION 3 ADJUSTMENT
The difference point(s) compared with the reference model are as follows.
DELETE
3.3.2 Video circuit 3.3.2.1 3.3.4.1 3.3.4.2 EE Y/PB Y (S-VHS/VHS) LEVEL Colour difference level SECAM burst position 3.3.4 PAL/SECAM converter circuit [EF model]
Adjustment procedure and value are changed.
3.3.1 Servo circuit 3.3.1.1
Signal Mode Equipment Measuring point External trigger Adjustment part Specified value Adjustment tool
Switching point
(A1) (A2) (B) (C) (D1) (D2) (E) (F) (G) (H) � � � � � � � � � � Stairstep signal Alignment tape(LP,stairstep,PAL) [MHPE-L] PB Oscilloscope VIDEO OUT terminal (75 ohm terminated) TP106 (PB. FM) TP111 (D.FF) Jig RCU: Code �5A� 6.5 ± 0.5H Jig RCU [PTU94023B]
(1) Play back the signal (A1) of the alignment tape (A2). (2) Apply the external trigger signal to D.FF (E) to observe the VIDEO OUT waveform and V.PB FM waveform at the measuring points (D1) and (D2). (3) Set the VCR to the manual tracking mode. (4) Adjust tracking so that the V.PB FM waveform becomes maximum. (5) Set the VCR to the Auto adjust mode by transmitting the code (F) from the Jig RCU. When the VCR enters the stop mode, the adjustment is completed. (6) If the VCR enters the eject mode, repeat steps (1) to (5) again. (7) Play back the alignment tape (A2) again, confirm that the switching point is the specified value (G).
Trigger point Switching point V.sync
V. rate
Fig.3-3-1a Switching point
(No.82979)1-5
|
|
|
> |
|
