|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent service and prompt delivery. But it's not a manual - only 4 pages wiring diagrams.
Thanks.
 ;
The manual I purchased was exactly what I needed to repair my Toshica television. The manual contained schematics and troubleshooting information that was very helpful.
;
Il download del Service Manual JVC HR 4100 non é stato eseguito
;
The Service Manual was just as expected, complete with schematics and I was able to download it in less than an hour after I ordered it. The only problem with these is that the schematics are hard to read due to the small font. I could remedy this by printing them on a larger printer.
;
Very fast, clear and usefull site !
Also this Service Manual are very well maked and with a very good definition !
Very fast download speed !
Recomended Seller !
WHEN REPLACING EEPROM (MEMORY) IC
If a service repair is undertaken where it has been required to change the MEMORY IC, the following steps should be taken to ensure correct data settings while making reference to TABLE 1. NOTE: No need setting for after INI 2D. INI 00 10 20 +0 0A AF 29 +1 30 97 02 +2 9A 95 00 +3 24 8A 71 +4 64 A0 66 +5 64 55 31 +6 4A 31 29 +7 86 04 04 +8 0B 88 00 +9 2F A5 00 +A 86 9F 00 +B 34 3A 05 +C 8A 00 A2 +D 08 10 B0 +E 0A BF 00 +F 0F 00 ---
Table 1 1. Connect the set to TV Monitor. 2. Turn on the POWER. 3. Press both CH UP button on the set and the FF button on the set for more than 2 seconds. ADDRESS and DATA will appear on TV Monitor as Fig 1. 4. ADDRESS is now selected and should �blink�. Using the SET + or - button on the remote, step through the ADDRESS until required ADDRESS to be changed is reached. 5. Press ENTER to select DATA. When DATA is selected, it will �blink�. 6. Again, step through the DATA using SET + or - button until required DATA value has been selected. 7. Pressing ENTER will take you back to ADDRESS for further selection if necessary. 8. Repeat steps 4 to 7 until all data has been checked. 9. When satisfied correct DATA has been entered, turn POWER off (return to STANDBY MODE) to finish DATA input. The unit will now have the correct DATA for the new MEMORY IC.
ADDRESS DATA
INIT 00 0A PLAY/REC 0010
Fig. 1
SERVO TIMING CHART
VCR MT PCB IC3001 (OEC0125A)
DPG 104 PIN
DFG 104 PIN 24 Cycle H. SW. P 105 PIN CH 1 CH 2
V-SYNC (E-E) 111 PIN
REC CTL (REC) 7 PIN V-SYNC (TRICK PB) 109 PIN
� WAVEFORM CHANGES DEPENDED ON THE TAPE SPEED
1-2
|
|
|
> |
|
