|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This manual was exactly what i needed and could not find elsewhere. Price is not too high. Great !
;
ecelent I was reciver the service manual soon I fell so happy very complete 100% positive all by this store tanks atte Luis salazar
 ;
A great copy of the manual, and the only one I could find anywhere on the net! The circuit diagrams are easily readable, all component values marked and easy to see. A highly appreciated download!
;
Great Manual. This manual is available no where else. It was exactly what I was looking for.
;
The TEAC A-1500's Service Manual was instrumental in reviving this classic reel-to-reel. Not only does it have the schematics, exploded parts diagram and parts list, it also provided mechanical adjustment information that approximate factory default settings.
DISASSEMBLY INSTRUCTIONS
1. REMOVAL OF MECHANICAL PARTS AND P.C. BOARDS
1-1: TOP CABINET AND FRONT CABINET (Refer to Fig. 1-1) 1. 2. 3. 4. 5. 6. 7. Remove the 5 screws 1. Remove the Top Cabinet in the direction of arrow (A). Disconnect the following connector: (CP651). Unlock the 8 supports 2. Remove the Front Cabinet in the direction of arrow (B). Remove the 2 screws 3. Remove the Operation PCB in the direction of arrow (C).
Top Cabinet
1-3: DVD DECK (Refer to Fig. 1-3) 1. Make the short circuit on the position as shown Fig. 1-3 using a soldering. If you remove the DVD Deck with no soldering, the Laser may be damaged. 2. Unlock the support 1 and remove the Deck Top Holder in the direction of arrow (A). 3. Remove the 2 screws 2. 4. Remove the screw 3. 5. Remove the screw 4. 6. Disconnect the following connectors: (CP2601, CP2602, CP2603). 7. Remove the DVD Deck in the direction of arrow (B). 8. Remove the 3 screws 5. 9. Remove the Front Angle in the direction of arrow (C). 10. Remove the screw 6. 11. Remove the DVD Angle.
DVD Deck Deck Top Holder
1 1
1 1
4 3
Pick Up PCB
2
(A)
1
Front Cabinet
1 2
(B)
2 2
2
3 2 2
(A)
3
CP651 Operation PCB
(B)
Make the sort circuit using a soldering. DVD Angle
2 2
(C)
2
5
Fig. 1-1 1-2: FLAP (Refer to Fig. 1-2) 1. Open Flap to 90� and flex in direction of arrow (A), at the same time slide in direction of arrow (B). 2. Then lift in direction of arrow (C). NOTE
5
5
(C) CP2601 CP2603 CP2602
6
Front Angle
Fig. 1-3
(A)
When the installation of the DVD Deck, remove all the soldering on the short circuit position after the connection of Pick Up PCB and DVD PCB connector.
(C)
(B)
Flap
Fig. 1-2
1-1
|
|
|
> |
|
