|
There are currently no product reviews.
 ;
A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
 ;
The quality of the manual is top. The transfer worked perfect and fast.
No problems at all. Recommendable
;
Very good service for get any documentation. Fast and perfect quality.
;
Excellent service manual with all the necessary info. :)
;
The product dowload was delivered efficiently with emails to support its download availabilty. The contets of the manual was very eligible and of good quality. Will purchase from this site again!
3.2.4 Removing the loading motor (See Figure 3-2k and Figure 3-2l) � Prior to the following procedure, remove the tray, the traverse mechanism assembly, and the elevator. (1) Remove the belt from the pulley. (2) Remove two screws C attaching the loading motor. (3) Remove two solders h on the switch board.
Belt Pulley C
Loading base Slide cam
Pulley C
Fig.3-2k
Switch board Part h
Loading motor
Fig.3-2l 3.3 Traverse mechanism assembly
3.3.1 Removing the pickup (See Figure 3-3a, Figure 3-3b) � Prior to the following procedure, remove the traverse mechanism assembly. (1) Remove one screw D attaching the plate. (2) Remove the plate and the leaf spring. (3) Lift i of the shaft 1, and pull out the shaft 1 from j. (4) Remove k of the pickup from the shaft 2. Attaching the pickup: (1) Engage k of the pickup to the shaft 2. (2) Insert the shaft 1 in j, and attach the shaft 1 to i. (3) Attach the leaf spring, and then attach the plate. Fix the leaf spring and the plate by using the screw D.
D Leaf spring Plate
Fig.3-3a
Shaft 2 Part j
Part k
Shaft 1 Part i
Fig.3-3b 1-14 (No.YD008)
|
