|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
3.2
Loading mechanism assembly
3.2.1 Removing the tray (See Figure 3-2a, Figure 3-2b, Figure 3-2c, Figure 3-2d, Figure 3-2e, Figure 3-2f) (1) Push a of the slide cam on the hole in the right side of the Tray loading base by using a driver until it stops. (See Figure 32a.) (2) The tray comes out. Pull the tray in a front direction until it stops. (3) Remove the two screws A attaching the slide bracket. (See Figure 3-2b.) (4) Tilt the tray in a direction of the arrow around the point in the left rear part of the tray. (See Figure 3-2c.) (5) The rail of the tray is removed from b of the loading base. Then, remove the tray upward. (See Figure 3-2d.) Attaching the tray: Engage c of the loading base to the projection of the tray while tilting the tray to the left. Turn the tray in a direction of the arrow, and attach the slide bracket. (See Figure 3-2e.) Note: Prior to the procedure above, move the slide cam in a direction of the arrow so that d of the slide cam can be inserted in e of the tray. (See Figure 3-2f.)
The point in the left rear part Fig.3-2c
Tray
Loading base part b
Rail of the tray
Fig.3-2d
Push Slide cam part a Fig.3-2a Loading base Projection of the tray Tray
A
Slide bracket
A
Loading base part c
Fig.3-2e
Part e
Fig.3-2b
Part d
Slide cam
Fig.3-2f
1-12 (No.YD052)
|
|
|
> |
|
