|
There are currently no product reviews.
 ;
Awesome manual. Complete diagrams of all board assemblies as well as how to get to each part of the t.v. down to the individual screws and their locations. Get it.
;
perfect copy, im very satisfied, i was need the diagram over the powersupply and
the copy was very sharp
;
This is exactly the service manual I needed.
Complete with all schematics, partslists, PCB layouts and alignment instructions.
This manual covers both the T-4970 en T-488F Onkyo tuner.
 ;
IF PRINTED CIRQUIT BOARD WIRING VIEW WAS ONE TONE LIGHTER, THEN 5 STAR RANK HAS TO BE MY CHOISE.
;
Very usefull, good quality drawings !
Muito útil encontrei todas as informações necessárias.
3.2
Loading mechanism assembly
3.2.1 Removing the tray (See Figure 3-2a, Figure 3-2b, Figure 3-2c, Figure 3-2d, Figure 3-2e, Figure 3-2f) (1) Push a of the slide cam on the hole in the right side of the Tray loading base by using a driver until it stops. (See Figure 32a.) (2) The tray comes out. Pull the tray in a front direction until it stops. (3) Remove the two screws A attaching the slide bracket. (See Figure 3-2b.) (4) Tilt the tray in a direction of the arrow around the point in the left rear part of the tray. (See Figure 3-2c.) (5) The rail of the tray is removed from b of the loading base. Then, remove the tray upward. (See Figure 3-2d.) Attaching the tray: Engage c of the loading base to the projection of the tray while tilting the tray to the left. Turn the tray in a direction of the arrow, and attach the slide bracket. (See Figure 3-2e.) Note: Prior to the procedure above, move the slide cam in a direction of the arrow so that d of the slide cam can be inserted in e of the tray. (See Figure 3-2f.)
The point in the left rear part Fig.3-2c
Tray
Loading base part b
Rail of the tray
Fig.3-2d
Push Slide cam part a Fig.3-2a Loading base Projection of the tray Tray
A
Slide bracket
A
Loading base part c
Fig.3-2e
Part e
Fig.3-2b
Part d
Slide cam
Fig.3-2f
1-12 (No.YD052)
|
