|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
NOTE: The customer is responsible for the correct selection and use of mounting hardware (available through hardware stores) that will ensure the proper and safe wall-mounting of the speakers.
WALL-MOUNTING THE SATELLITES
The satellite speakers can be wall- or ceiling-mounted, as shown in Figures 5 and 6. You can mount the speakers with #6 wood screws (not included), using the built-in mounting bracket. Use the enclosed template to mark the desired position of each speaker on a wall or ceiling. Locate a stud for secure mounting and use heavy-duty wood screws with long threads. Test the mounting thoroughly before installation.
VERTICAL MOUNTING...
To mount the speaker vertically on a wall, fasten the wood screws (not included) to a wall stud, leaving a 3�16" clearance between the base of the screw head and the wall. If desired, loosen the bracket screw, adjust the bracket angle, and tighten the bracket screw. NOTE: You may want to route the wires before tightening the bracket screw (see Figure 8 on page 11). Then orient the speaker vertically, align the crossholes on the rear of the speaker with the wood screws, and slide the speaker down.
Figure 5. This illustration shows how to mount the speaker vertically on a wall or ceiling four different ways.
(rear view)
VERTICAL MOUNTING USING BRACKET
� Loosen Screw � Rotate Bracket � Tighten Screw
Screw (inside hole)
3/16" wall wood screw (side view)
Positions
(top view)
Slide Speaker Down Onto Wood Screws
#6 Wood Screws (fasten to wall stud)
20° From Wall (Bracket Closed)
45° From Wall (Bracket Open, Position #1)
67.5° From Wall (Bracket Open, Position #2)
90° From Wall (Bracket Open, Position #3)
HTS-20 Home-Theater System � Owner�s Manual x 9
|
|
|
> |
|
