|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
;
The manual is of better quality compared to other. I found it less expensive and therefore it it is the best buy cost vs quality.
 ;
I bought the service-manual of the sony ICB-1020(an old transmitter-receiver) at "www.Owners-Manual.com", I found the service-manual for a fairly cheap price(in comparison with other sellers). I filled in some questions, payed the order with Ideal, and within 24 hours I had my service manual. I was very happy:In no time I had my service-manual and everything, but literally everything was noted down in the manual; the electronic scheme, the parts list, etcetera.
A very practical, reference-document.
;
This comprehesive service maual was greatly appreciated, as was the digital download.
;
Good en helpfull black and white scanned Srfvice manual of the Philps D8444. Quick service and delivery
DECK MECHANISM ADJUSTMENT
5. Audio/Control (A/C) Head Adjustment
Purpose: To insure that the Tape passes accurately over the Audio and Control Tracks in exact Alignment in both the Record and Playback Modes.
5-1. Preliminary Adjustment (Height and Tilt Adjustment) Perform the Preliminary Adjustment, when there is no Audio Output Signal with the Alignment Tape. Test Equipment/ Fixture
� Blank Tape � Screw Driver(+) Type 5mm
-0.05
Test Conditions (Mechanism Condition)
� Play the blank tape
Adjustment Point
� Tilt Adjustment Screw(C) � Height Adjustment Screw(B) � Azimuth Adjustment Screw(A)
Adjustment Procedure/Diagrams
1) Initially adjust the Base Assembly A/C Head as shown Fig. C-5-1 by using the Height Adjustment Screw(B). 2) Play a Blank Tape and observe if the Tape passes accurately over the A/C Head without Tape Curling or Folding. 3) If Folding or Curling is occured then adjust the Tilt Adjustment Screw(C) while the Tape is running to resemble Fig. C-5-3. 4) Reconfirm the Tape Path after Playback about 4~5 seconds.
NOTE
Ideal A/C head height occurs, when the tape runs between 0.2~0.25mm above the bottom edge of the A/C head core.
A/C Head P4 Tape
10.9
Tape
0.2~0.25mm
A/C Head Base Fig. C-5-1 Fig. C-5-3
X-Value Adjustment Hole
Fixed Screw
Azimuth Adjustment Screw(A)
Tilt Adjustment Screw(C) Height Adjustment Screw(B)
A/C Head Assembly Fig. C-5-2
82
|
|
|
> |
|
