|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
;
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
 ;
The owners manual is very good. all my how to questions were answered in detail.
;
Irrespectively of this manual exist only germany language, it's useful - although i need some additional task to translate: My english is bad, but usable - but i really dont speak germany. :)
Service and Maintenance (cont'd)
Draining
The water heater should be drained if being shut down during freezing temperatures. Also periodic draining and cleaning of sediment from the tank may be necessary. 1. Before beginning turn "OFF" the electric power supply to the water heater.
Thermostat
Removal
1. Turn "OFF" the electrical power to the water heater at the junction box.
AWARNING
HAZARD OF ELECTRICAL SHOCK! Before removing any access panels or servicing the water heater, make sure the electrical supply to the water heater is turned "OFF". Failure to do this could result in DEATH, SERIOUS BODILY INJURY, OR PROPERTY DAMAGE.
A WARNING HAZARD OF ELECTRICAL SHOCK! Before removing any access panels or servicing the water heater, make sure the electrical supply to the water heater is turned "OFF". Failure to do this could result in DEATH, SERIOUS BODILY INJURY, OR PROPERTY DAMAGE.
2. 2,
Remove the access panel and the insulation block. Lift out the tab as shown below to uncfip the terminal cover from the thermostat. The terminal cover can now be removed from the thermostat.
2. CLOSE the cold water inlet valve to the water heater, 3. OPEN a nearby hot water faucet and leave open to allow for draining. 4. Connect a hose to the drain valve and terminate to an adequate drain or outdoors, 5. OPEN the water heater drain valve to allow for tank draining. NOTE: If the water heater is going to be shut down and drained for an extended period, the drain valve should be left open with hose connected allowing water to terminate to an adequate drain. 6. Close the drain valve. 7. Follow "Filling the Water Heater" instructions in the "Instructions for Installation" section. 8. Turn "ON" power to the water heater.
terminal from thermostat. cover (
ip
LOWER THERMOSTAT WITHOUT HIGH LIMIT
UPPER OR LOWER THERMOSTAT WITH HIGH UMIT
4. Remove the two wires attached to the thermostat.
A CAUTION
Never use this water heater unless it is completely full water. To prevent damage to the tank and heating element, the tank must be filled with water. Water must flow from the hot water faucet before turning "ON" power. 5. Remove the thermostat from behind the thermostat bracket. 6. Disconnect wires from thermostat and slide out ofthebracket. 7. Place the new lower thermostat in the bracket making sure it fits firmly against the tank. 8. Attach the wires to the new thermostat. NOTE: Some of the terminals may require straight-in wiring through an eye-opening. If wires are now looped, re3 /t cut and strip wire/s to a straight length and insert. 17
|
|
|
> |
|
