|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I was having a hard time finding the problem with this Mackie 1604 unit. I didn't have a schematic. Went looking on the web and found your site and the price was more then reasonable. Ordered it and within the hour had the manual and within 15 minutes had the unit fixed. Best $4.99 I ever spent. Thank you.
Doug
;
This is a service manual in every sense of the word ( French and German versions of the text are included, as well as English..)
There are explanations of the mechanical and electrical functions, plenty of mechanical drawings, and the needed schematics. The quality of the scanning is excellent - all the component values are clearly legible - and very usefully there are pcb component layouts, so you can find a component on the schematic, and then very quicky pinpoint its physical location on the relevant pcb.
I cannot see how I can give this manual any less than the maximum 5 stars! Great value for money, which will pay for itself immediately. Excellent all round!
;
the manual is great and especially hard to find... thanks for the great service and having a hard to find manuel_
;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.50 of store credit for Your review.
;
hat alles sehr gut geklappt. Das Servicemaual ist gut zu verwenden. Die Pläne und Schrift
ist klar und leserlich. Außerdem preiswert. Grüße an alle Hifi-Bastler
ICD-47 SECTION 4 TEST MODE
[Setting Method of Test mode]
Short TP701 (TEST) on the MAIN board with a solder bridge (connect pin yf of IC701 to the ground). Then, turn on the power. 1. Audio test � A howling occurs with �5P DSP LOOP� displayed on the LCD, if the [REC START/STOP] key is pressed. � The mute turns on, if [ > +] key is pressed. � The mute turns off, if [-- .] key is pressed. � The microphone sensitivity becomes high, if the [HOLD] switch turned off. � The microphone sensitivity becomes low, if the [HOLD] switch turned on. 2. Sleep/Wake up test � Pressing the [Nx] key causes the set to enter sleep state. � Pressing another key causes the set to release sleep state. 3. LCD check � LCD light up all, if the [STOP] key is pressed. � Even segment of LCD light up as shown below, if the [FILE] key is pressed. LCD display
� MAIN BOARD (Side A) �
REC DATE
M D Y M M S D
� Odd segment of LCD light up as shown below, if the [ERASE] key is pressed. LCD display
SP LP
REMAIN
4. Beep sound check � A beep (2.4 kHz) is kept sounding, if the [MENU] key is pressed. � A beep stop sounding, if another key is pressed. 5. Power supply check � The battery is on the O.K. level when the [OPR] LED lights in green only, or it is off. � The battery is on the mark lighting level when the [OPR] LED lights in green and blinks in red repeatedly. � The battery is on the inactive level when the [OPR] LED blinks in red only.
(
Short Open
TP701 : Test mode : Normal mode
)
[Releasing Method of Test Mode] Turn off the power. Then, open the solder bridge on TP701 (TEST) on the MAIN board. [Operation of Setting on Test Mode] When the test mode is set, the LCD displays �TEST� and [OPR] LED lights in green. Note: The [OPR] LED turn off, if a key operated.
6
 $4.99 ICD-47 SONY
Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|
