|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Another excellent buy! A fully readable PDF archive. Good prints!!
;
It is wonderful done!!! a great job in scanning the manual. Superior quality in all the electric scheme. Very understandable and net!!! Thank you!
 ;
muy buen manual por lo completo de este algunos esquemas estan muy divididos lo que hace algo dificil el seguimiento.
;
very good manual, with detail and clarity in esquematic diagrams and waveforms .
;
Very quality copy of original service manual, which contains the circuit diagrams, PCB and lists of components, well as recommendation for calibration procedures of device, also everything else, that need for repair, tuning and use this oscilloscope.
All presented copies have high-resolution, so you can view all in detail.
This manual will very useful for simple owners and for repairers.
I recommend these manual, because myself is owner of Philips PM3216 and I need sometimes servicing these oscilloscope (principally calibrating).
Also, these document is an example of excellent design of technical documentation.
ICD-P320
H
HOLD ON
� SUSPEND Test With the VBUS ON, turn the [HOLD] switch ON to enter the SUSPEND mode. When this mode is cancelled, the VBUS is turned OFF. with VBUS
Sensitivity H
H
Nx PLAY/STOP (ENTER)
k
L
HOLD
K
OFF
x STOP
J
Sensitivity L
x STOP
j
HOLD ON
To change the sensitivity again, press the x STOP button and change the [HOLD] switch. In a DSP Test mode, changing the mode and changing the sensitivity require the x STOP button be pressed. 5-5. USB Test In this test, the ON/OFF status of VBUS is displayed and the SUSPEND test is performed. The Nx PLAY/STOP(ENTER) button is pressed to display the status of VBUS by �On� or �OFF� indication. With the VBUS ON, the [HOLD] switch is operated (ON) to perform the SUSPEND test. � VBUS Test with VBUS
H
K
VBUS OFF
SUSPEND mode 5-6. RESET MENU To enter the RESET MENU test, press the [DIVIDE] button. When all of the buttons or controls located on the set are operated, the system shows �Ok� if all of them are normally operated. An operation of a switch is indicated by the number for verification in order to make a simple indication. Note 1: When 10 different operations of the switches are normally made in any order (regardless of the order that pushbuttons are pressed and the slide switch is set to ON and OFF), the system shows �Ok�. Note 2: Clear memory when �ACCESS� is blinking on the display. (Do this before �Ok� is shown.) To exit from this menu, the power has to be turned off (battery to be removed).
Nx PLAY/STOP (ENTER)
k
K
x STOP
without VBUS
7
|
|
|
> |
|
