|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
English
18. Altering the operating voltage and frequency (Reserved for technical staff only)
If the factory preset operating voltage and frequency do not correspond to those in use in your country of operation, you may alter the settings as described in the following paragraphs. Incorrect selection of operating voltage and frequency will seriously compromise the functioning of the projector.
Opening up the projector
To carry out the following procedures, the projector housing should be open, Instructions for opening up the unit can be found in sections 19 of this manual.
18.1 Selecting the voltage on the autotransfomer
After having opened up the rear of the unit: 1) Locate the autotransformer on the left of the unit.
2) Select a voltage from amongst 100, 115, 208, 230 and 240V by removing cable n° 8 and moving it to the required voltage. To determine which is the correct tap, refer to the sticker located on the autotransformer.
Connections 9, 7 and 15 should not be moved under any circumstances. If in doubt, consult the circuit diagram or refer the unit to specialist trained personnel. 4) If the operating voltage selected is either 100 or 115V, replace the 5 Amps T fuse (which is suitable for 208/230/245 V operation) with one rated at 8 Amps T. The fuseholder is located near the base of the unit. The operation should be reversed should the voltages be reversed.
8AT @115V 5AT @230V 5) Operating frequency may now be set (if necessary) as shown in the next section.
23
|
|
|
> |
|
