|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
 ;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
;
Fast service, document is OK. Thanks! Searched for it long time.
;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Building-in instructions
Dimensions of housing Model IKE 197-7 IKE 247-6 Height 1030 mm Depth Width 550 mm 560 mm 1225 mm 550 mm 560 mm
50 mm
min. 2 200 cm
Temperature regulation
The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings.
min. 200 cm2
Important If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption.
However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: � room temperature; � how often the door is opened; � the quantity of food stored; � location of appliance. A medium setting is generally the most suitable.
For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction.
D567
Fresh food refrigeration
To obtain the best performance: � do not store warm food or evaporating liquids in the refrigerator; � do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it.
540
50
B
It is necessary that the niche is provided with a conduct of ventilation having the following dimensions: Depth 50 mm Width 540 mm
PR01
T
H
�
Fit the appliance in the niche by making sure that it stands against the interior surface of the unit on the side where the door hinges of the appliances are fitted. Insert the appliance until the upper strip butts up against the unit (1) and make sure that the lower hinge is in line with the surface of the unit (2).
Shelf holders
1
Yourappliance is equipped with shelf retainers that make it possible to secure the shelves during transportation. To remove them proceed as follows: Raise the shelf from the back, push it in the direction of the arrow until it is freed and remove the retainers.
A
B
2
D022
Fasten the appliance with 4 screws provided in the kit included with the appliance.
Movable shelves
The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired.
I
D338
Apply the sealing strip pushing it between the refrigerator and the adjacent cabinet.
Positioning the door shelves
To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required.
D724
PRXXX
16
13
|
|
|
> |
|
