|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I am only search for 5 Minute, by it in 5 Minutes to and get ist in few ours! Best i found in the Internet and my Amplifer is repaired as well! Thank you
 ;
Readable text and good copy. Very much needed if you wish to do some repairs on this fine old unit.
;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
IL60 L/R Controls and Connections
The Interlude IL50 and IL60 offer unprecedented flexibility for connecting the system to any type of audio or home-theater system. Consult the table at right to determine which system description most closely matches your own, then follow the hook-up method corresponding to that system. If none of these system configurations seem to match yours, consult your dealer or Infinity customer service for direction on how best to hook up your system. For methods 2, 3a, 3b and 4, make sure all bass-management features are properly set. The Audio channels should all be set to �Small� or �High-Pass� and the subwoofer set to �On.�
System Type
2-Channel receiver or integrated amplifier that has no subwoofer output or Pre-out/Main-In connectors 2-Channel receiver or integrated amplifier with preamp output and input connectors 2-Channel system with separate preamplifier and power amplifier Dolby* Pro Logic* with THX®, Dolby Digital, or DTS® receiver with a filtered subwoofer (or LFE) output connector Dolby Digital or DTS processor with separate power amplifiers or multichannel amplifier Non-THX certified Dolby Pro Logic receiver with full-range subwoofer outputs
Connection Methods
1 2 2 3a
3b 4
RED = + METHOD 1 BLACK = 1. LOOSEN TERMINALS 2. INSERT BARE END: TIGHTEN TERMINALS 3. SET INPUT SUB TO "SPEAKER"
(ONE CHANNEL SHOWN)
AMPLIFIER/RECEIVER
SPEAKER OUTPUTS
3
STRIPE= +
+
-
+
-
+
4. SET LOW-PASS FILTER "ON"
4
®
NO STRIPE = -
O
RED = + METHOD 2 BLACK = 1. LOOSEN TERMINALS 2. INSERT BARE END: TIGHTEN TERMINALS 3. SET INPUT SUB 3 TO "LINE LEVEL" STRIPE= + 4. SET LOW-PASS FILTER 4 "ON" NO STRIPE = + LEFT -
AC CORD
AMPLIFIER/RECEIVER SPEAKER OUTPUTS
SPEAKER OUTPUTS
00354
-
+ RIGHT
+
®
O
AC CORD
(ONE CHANNEL SHOWN)
PREAMP OUTPUTS
L
AMPLIFIER INPUTS
L
R
R
7
00359-2
|
|
|
> |
|
