This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
Text excerpt from page 22 (click to view)
APPENDIX
Wall Mounting the Intermezzo 2.6 Using an OmniMount® 75 WB Wall Bracket Important Note: Proper installation of these brackets
is the exclusive responsibility of the customer and the manufacturer disclaims any liability for the mounting hardware and bracket installation.
3. Loosen the Adjustment Bolt on the front of the Speaker Mount
so that the jaws of the Socket Cup will accept the ball of the Wall-Mount Arm. Socket-Cup
Jaws Adjustment Bolt Speaker Mount
Important Safety Note: Due to the Intermezzo 2.6
bookshelf speaker�s weight, it is recommended that two people mount the speaker to the 75 WB wall bracket.
1. After mounting the 75 WB bracket to the wall, following the
mounting instructions provided with the bracket, reassemble as shown. Make sure to screw the Self-Locking Nut down until the nylon ring at the top engages at least 2 or more threads to Self-Locking Nut cause it to become secure.
Lower Tightening Nut Wall-Mount Arm Ball
75 WB Wall Bracket
�U�-shaped bracket attaches to the wall
4. Lift the speaker/Speaker-Mount assembly onto the Wall-Mount
Arm so that the ball fits into the Socket Cup. Adjust the speaker to the desired position. While holding speaker, tighten the Adjustment Bolt until the Socket-Cup Jaws hold the speaker assembly securely in place. Adjust Arm to desired speaker position and tighten the lower bolt. Snap the Wall-Bracket Cover on.
2. Turn the Intermezzo 2.6 bookshelf speaker upside down
and attach the Speaker Mount to the base of the speaker with (4) 1/4-20 x 1/2" length bolts (included with the speakers). No other hardware is recommended for this use.
(4) 1/4-20 x 1/2" Bolts
