|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
;
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
;
Very good scanning quality. All schematics are very legible. Worth every cent !
CHAPTER 7 TROUBLESHOOTING
1.3.4.3 Original Speed Adjustment Adjust the speed at which originals are moved for ADF mode as follows: 1) Make a copy of the test sheet in ADF mode on paper of the same size in Direct. (See 1.2.2 of Chapter 7.) 2) Measure the length �L� in the middle of the copy output. (It must be 277 ± 1 mm for A4, 259 ± 1 mm for LTR.)
(feeding direction) L
Copy of the test sheet
F07-103-06 3) 4) 5) 6) 7) 8) 9) Press the Additional Functions key and the # key to start service mode. Press the Left/Right Arrow key so that �#6 SCANNER� is indicated. Press the OK key. Press the Left/Right Arrow key so that �7: CCD� is indicated. Press the OK key. Press the Left/Right Arrow key so that the 2nd row of the LCD indicates �034:�. Enter a appropriate correction value using the Left/Right Arrow key so that the length of L measured in step 2) is as indicated. (An increase by �1� will increase the length of L by about 0.5 mm.) 10) Press the OK key. 11) Press the Stop key (to end SCANNER). 12) Make a copy of the test sheet in ADF mode on paper of the same size in Direct; then, check to make sure that the length of L of the copy is as indicated. 13) End the work if the length of L is as indicated; otherwise, start over with step 2).
COPYRIGHT © 2002 CANON INC. 2000 2000 2000 2000 CANON iR1200/iR1300 Series REV. 0 AUG. 2002
7-13
|
|
|
> |
|
